Page 3
MAKMAK
MAKMAK
MAK
OO
OO
O
, BARRACUD, BARRACUD
, BARRACUD, BARRACUD
, BARRACUD
A & BARRACUDA & BARRACUD
A & BARRACUDA & BARRACUD
A & BARRACUD
A PLA PL
A PLA PL
A PL
US INSTRUCTIONSUS INSTRUCTIONS
US INSTRUCTIONSUS INSTRUCTIONS
US INSTRUCTIONS
This symbol points out important safety
instructions which if not followed could
endanger your personal safety. Read and
follow all instructions in this manual and
any others provided with this equipment.
1. The ice blade is very sharp. Use extreme caution when
drilling a hole, replacing the blade or blade guard.
2. Do not carry the auger powerhead between holes with
the engine running.
3. The auger should not rotate when the engine is idling.
If it does rotate when engine is idling, contact
Ardisam, Inc. for instructions.
4. Always keep hands, feet, hair and loose clothing away
from any moving parts on engine and auger.
5. Do not allow children to operate this power auger. Do
not allow adults to operate the auger without proper
instruction.
6. Do not operate any power equipment under the
influence of alcohol or drugs.
7. Keep all screws, nuts and bolts tight.
8. Engine should be shut off before any repairs are
attempted.
9. Temperature of muffler and nearby areas may exceed
150° F (65° C). Avoid these areas.
10. Never run engine indoors or in enclosed, poorly
ventilated areas. Engine exhaust contains carbon
monoxide, an odorless and deadly gas.
OPERAOPERA
OPERAOPERA
OPERA
TIONTION
TIONTION
TION
OPERAOPERA
OPERAOPERA
OPERA
TIONTION
TIONTION
TION
1. Read engine operating manual and follow instructions
for fuel type, starting, etc. BE SURE TO USE
PROPER GAS/OIL MIXTURE.
2. The clutch will transfer maximum power after about
two hours of normal operation. During this break-in
period clutch slippage may occur. The clutch should be
kept free of oil or other moisture for efficient operation.
3. Dig holes without placing excessive body weight on the
unit. The auger operates most efficiently with a shaving
action caused by the weight of the unit itself.
4. Never run engine indoors. Exhaust fumes are deadly.
5. Do not use an ice auger in earth.
6. The ice auger blade protector should be attached to the
auger head when not in use. This will protect the cutting
edge of the ice auger blade.
FUEL MIXTUREFUEL MIXTURE
FUEL MIXTUREFUEL MIXTURE
FUEL MIXTURE
1. Mix clean, fresh, lead-free gasoline (minimum of 77
octane) with a high quality 2 cycle engine oil at the ratio
of 5 oz. oil to 1 gallon gasoline. (Refer to your engine
manual for further information on fuel.)
2. Mix fuel in a 1 or 2 gallon container approved for
gasoline.
3. Loosen fuel cap slowly. Rest the cap on a clean surface.
4. Carefully pour fuel into the tank. Avoid spillage.
5. Immediately replace fuel cap and hand tighten. Wipe up
any fuel spillage.
Please do not start your auger until you have read the
Engine Manual that came with your engine, and the
section in this manual titled Safety. If you have read
these, follow the steps below to start your auger.
Always perform this pre-start checklist before starting
the engine.
CAUTION
This engine uses a gas/oil mixture. DO NOT RUN
ENGINE ON STRAIGHT GAS ONLY. ENGINE DAMAGE
WILL RESULT!
Never fill fuel tank indoors. Never add gas when engine
is running or hot from operation. Do not smoke when
filling fuel tank.
CAUTION
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce